Home / Ford Small Block Compatible 302 c.i. Engine and 4R70W Automatic Transmission - 365 Horsepower - Bronco Edition Builder Series - Black Pulley Kit - Carbureted

Ford Small Block Compatible 302 c.i. Engine and 4R70W Automatic Transmission - 365 Horsepower - Bronco Edition Builder Series - Black Pulley Kit - Carbureted

Quantity
ADD TO CART
BUY IT NOW
  • Detail

    Description: 

    • Horsepower & Torque: 365 Horsepower / 365 ft. lbs. Torque
    • Compression Ratio: 10.0:1
    • Aluminum Heads
    • Hydraulic Roller Cam
    • Hypereutectic Pistons

    Block:

    • BluePrint Engines High Strength Cast Iron Block
    • Increased Deck Thickness and Strength Webbing
    • Priority Main Oiling
    • 4.000" Bore
    • 4-Bolt Main
    • 1-Piece Rear Main Seal
    • Improved Water Jacket Design

    Rotating Assembly:

    • Cast Crankshaft
    • 3.000" Stroke
    • OEM Type 5.090" Connecting Rods
    • Hypereutectic Pistons
    • 50oz Externally Balanced

    Cylinder Heads:

    • BluePrint Aluminum Cylinder Heads - HP9009
    • 60cc Chamber
    • 2.02" Intake / 1.60" Exhaust Valves
    • 190cc Intake / 60cc Exhaust Runners

    Cam Specs:

    • Cam Type: Roller
    • .533 Intake / .544 Exhaust Lift
    • 215 Intake / 220 Exhaust Duration
    • @.050-114 Degree Lobe Separation

    Ignition Timing:

    • 34 Degrees Total at 3500 RPM

    Also Includes:

    • Holley Street Warrior 600cfm Vacuum Secondary Carburetor w/ Electric Choke 
    • Front Accessory Drive with A/C Compressor, Water Pump, Alternator and Power Steering Pump
    • Dual Plane, Satin Aluminum Intake Manifold
    • Distributor
    • Valve Covers
    • Dual/Rear Sump Oil Pan
    • Electric Fuel Pump Included
    • Thermostat and Thermostat Housing

    Assembled with Complete 4R70W 4WD Ready – Automatic Trans Package:

    • Includes Electronic Transmission Controller
    • THROTTLE POSITION SENSOR NOT INCLUDED
    • Transmission Built to 650 HP
    • 2200-2600 Stall Torque Converter
    • Flex Plate
    • Starter
    • 4 Speed, Overdrive Transmission w/Lockup
    • Specifically Prepped for Dana 20 Transfer Case (1966-1976). Transfer case is NOT included
    • GEAR RATIOS
      • First: 2.84 :1.
      • Second: 1.55 :1.
      • Third: 1.00 :1.
      • Overdrive: 0.70 :1.
      • Reverse: 2.32 :1.

    Notes:

    • Does not include TPS sensor, as varies with each install. 
    • Package Ships assembled.
    • Note that 4R70W transmission may require modifications/replacement of driveshaft, transmission mount, exhaust routing, etc. 
    • The front accessory drive on this engine fits many vehicles, however it is the customer responsibility to accurately measure and confirm fitment.  Note this is a low-profile design, but things such as power steering hoses, alternator wiring, and additional fittings/fabrication may be required on some vehicles.
     
    • Customer Reviews
      No comments
    BACK